Nalim, M. Razi2014-02-262014-02-262000-11Nalim, M. R. (2000). Longitudinally stratified combustion in wave rotors. Journal of Propulsion and Power, 16(6), 1060-1068.https://hdl.handle.net/1805/4053A wave rotor may be used as a pressure-gain combustor, effecting wave compression and expansion, and intermittent confined combustion, to enhance gas-turbine engine performance. It will be more compact than an equivalent pressure-exchange wave-rotor system, but will have similar thermodynamic and mechanical characteristics. Because the allowable turbine blade temperature limits overall fuel-air ratio to subftammable values, premixed stratification techniques are necessary to burn hydrocarbon fuels in small engines with compressor discharge temperatures well below autoignition conditions. One-dimensional, nonsteady numerical simulations of stratified-charge combustion are performed using an eddy-diffusivity turbulence model and a simple reaction model incorporating a flammability limit temperature. For good combustion efficiency, a stratification strategy is developed that concentrates fuel at the leading and trailing edges of the inlet port. Rotor and exhaust temperature profiles and performance predictions are presented at three representative operating conditions of the engine: full design load, 40% load, and idle. The results indicate that peak local gas temperatures will cause excessive temperatures in the rotor housing unless additional cooling methods are used. The rotor temperature will be acceptable, but the pattern factor presented to the turbine may be of concern, depending on exhaust duct design and duct-rotor interaction.en-UScombustionwave rotorsArticle