Peng, MichaelMargetts, Tyler J.Sugali, Chenna KesavuluRayana, Naga PradeepDai, JiannongSharma, Tasneem P.Raghunathan, Vijay KrishnaMao, Weiming2023-10-172023-10-172022Peng M, Margetts TJ, Sugali CK, et al. An ex vivo model of human corneal rim perfusion organ culture. Exp Eye Res. 2022;214:108891. doi:10.1016/j.exer.2021.108891https://hdl.handle.net/1805/36378The human anterior segment perfusion culture model is a valuable tool for studying the trabecular meshwork (TM) and aqueous humor outflow in glaucoma. The traditional model relies on whole eye globes resulting in high cost and limited availability. Here, we developed a glue-based method which enabled us to use human corneal rims for perfusion culture experiments. Human corneal rim perfusion culture plates were 3D printed. Human corneal rims containing intact TM were attached and sealed to the plate using low viscosity and high viscosity glues, respectively. The human corneal rims were perfused using the constant flow mode, and the pressure changes were recorded using a computerized system. Outflow facility, TM stiffness, and TM morphology were evaluated. When perfused at rates from 1.2 to 3.6 μl/min, the outflow facility was 0.359 ± 0.216 μl/min/mmHg among 10 human corneal rims. The stiffness of the TM in naïve human corneal rim was similar to that of perfusion cultured human corneal rim. Also, the stiffness of TM of corneal rims perfused with dexamethasone was significantly higher than the control. Human corneal rims with glue contamination in the TM could be differentiated by high baseline intraocular pressure as well as high TM stiffness. Histology studies showed that the TM tissues perfused with plain medium appeared normal. We believed that our glued-based method is a useful tool and low-cost alternative to the traditional anterior segment perfusion culture model.en-USPublisher PolicyAnterior segment perfusion cultureAqueous humor outflowCorneal rimStiffnessTrabecular meshworkArticle